Tapcon Rod Hanger

Designed specifically for overhead threaded rod applications, the Tapcon Rod Hanger offers a fast alternative to traditional drop-in anchors - installed in less than half the time

Applications

Installed with the 328 24V SDS Hammer Drill and Condrive Kit or IWI280 Impact Wrench For the fastest, surest serial fixing of pipes, ducts, basket tray, trapezes, installing sprinkler systems and cable trays

RHT installation with IWI
Basket Tray Installation

Product Features

Shark’s teeth thread - The unique thread reduces torque required to set anchor and also provides a more substantial anchorage once set. The wider thread angle provides more mechanical interlock with the substrate. The low pitch of thread provides better resistance to cyclic loading

Maximised collar shape - Increases shear and torque loading resistance

Coupler locked on - Cannot loosen under vibrating load

6mm drill diameter (screw dia 7.5mm) - Smaller drill hole than drop-in anchors

RHT Features & Benefits Tour

Specification

Diameter	8mm
Threaded rod	M8 or M10
Threaded Length	35mm or 55mm
Thread form	Shark’s teeth thread
Point type	Nail
Finish	Delta Protekt Coating (screw only)

Installation

When installing the self tapping screw into concrete, use up to 1,200 RPM drill (maximum)

Use either a standard 6.5mm SDS / masonry drill bit or a Hex receiver drill bit for use with the concrete Condrive kit code 921433

Drill a hole in the base material to a depth of 54mm with an electric impact/drill set on impact mode

If using the Condrive system install the sleeve over the drill bit (the drill bit should remain in the tool)

Insert the appropriate nut driver in the sleeve (Black Nut driver code 921406)

Insert the concrete screw into the nut driver

Place the tip of the screw into the pre-drilled hole, ensuring it is switched to drill mode and begin insertion

When the nut driver spins free on the screw, installation is complete

Stop and remove the drill and screw threaded rod into the female threaded socket

Note: Do not install the concrete screws while the drill is in impact mode - doing so will destroy the pull-out factor of the screw. When fixing into pre-cast hollow concrete beams ensure Tapcon Rod Hanger is fixed into the web for best pull-out result

The installation sockets are designed with a unique automatic release mechanism to prevent over tightening. This provides a fast and safe installation each time. When the face of the driver comes in contact with the material you are installing into, continue drilling until nut driver spins free. Installation is then complete