Spit Rod Hanger Tapcon
Rod Hanger Tapcon Vertical for Steel the overhead threaded rod anchoring system
Applications
|
Fire protection - sprinkler systems, plumbing / Mechanical Contractors - air, water, hydraulics,
Electrical Contractors - conduit, cable trays, lighting, low voltage cabling, HVAC - unit heaters,
A/C units, duct work, refrigeration, industrial maintenance - work in the rafters
|
Product Features
| Installs in less than half the time of drop-in anchors |
| Single piece design, no nut and washer to assemble |
| Suitable for concrete, steel and wood based materials |
| Concrete installation requires smaller diameter drill bits than traditional drop-in anchors |
| All metal fixings offer fire resistance |
| Easily removable / replaceable |
| Close to edge fixing giving high performance values |
| Can be fixed closer together than traditional anchors without reducing performance values |
| Self tapping in concrete and cuts its own thread in wood and steel |
| Low cost Condrive kits allow fast installation |
| Allows vertical and horizontal installation in hard to reach locations |
| Premium corrosion protection |
| Shallow embedment gives flexibility in steel, concrete and wood |
| Steel version employs proven Teks technology |
Specification
| Diameter | 6.5mm |
| Threaded rod | M10 |
| Thread form | Self Tapping |
| Point type | Teks |
| Finish | Carbon Steel |
| Head style | Female M10 |
| Kesternich Results (DIN 5008, 2.0L) | 30 Cycles - 10% or less red rust Salt Spray Results
(ASTM B117) = 750 Hours - 10% or less red rust |
Installation
| Insert vertical installation Socket into 3 jaw chuck of rotary percussion drill |
| Note: 500 - 1,500rpm drill for installation into steel |
| Place Rod Hanger Tapcon into Socket (drill should be in a vertical position) |
| Ensure the Rod Hanger Tapcon and Socket are pressed firmly against the steel. ensure drill is not in hammer action mode |
| Drive Rod Hanger Tapcon until Socket spins free |
| Insert Threaded Rod |
| Add retainer nut and torque to 2.26N/mm2 for maximum pull-out in steel purlin |
| Note: If drill chips are blue in colour, this indicates drill RPM is too high |
Substrates
| Wood - joist, flooring, composite joist / truss, steel, concrete, pre-cast concrete beams, block work, brickwork
|
Product Range
| Code | Anchor Ø | Hole Ø | Length | Box Qty |
|---|
| 921410 | 6.5mm | Self Drill | 25mm | 25 |
Cut Box Range
| Code | Anchor Ø | Hole Ø | Length | Box Qty |
|---|
| 921541 | 6.5mm | Self Drill | 25mm | 20x4 |
Accessories
| Code | Description | Box Qty |
|---|
| 921405 | Universal Condrive Kit | 1 |
| 921406 | Vertical Installation Socket | 1 |
Approvals
| UL, FM, NFPA National Fire Protection Association |
